7 November 2022 – Amid this month’s Climate Change Conference in Sharm el-Sheikh,  European Aluminium, the industry association representing the aluminium value chain in  Europe, warns against the negative impact of immediately including indirect emissions in  the EU’s Carbon Border Adjustment Mechanism (CBAM). A premature inclusion without  finding a way to adequately reflect the unavoidable indirect costs that European producers  face in their electricity prices (even when consuming renewable electricity) would lead to  a rise in global CO2 emissions and offer little carbon leakage protection to Europe’s  decarbonisation champions. The industry supports the more cautious approach suggested  by the Council alongside the negotiators’ proposed improvements on product scope and  governance

Ahead of tomorrow’s round of trialogue negotiations on CBAM, European Aluminium believes it is of high importance  to properly evaluate the risk that the inclusion of indirect emissions in CBAM could have on the future of the aluminium  value chain in Europe. An immediate inclusion of indirect emissions in the CBAM, without the adequate safeguards  and review mechanisms assessing all downstream impacts and circumvention risks, would do considerable damage  to an industry that has already suffered from the impact of the current energy crisis. Instead, the industry calls on all  parties to apply the step-by-step approach put forward by Member State governments alongside the negotiators’  proposed improvements on product scope and governance. 

Over the past 15 years, Europe has lost one third of its primary aluminium production capacity due to the unfavourable  business conditions in Europe vis-à-vis other regions of the world. Since October 2021, 50% of the remaining EU production capacity – equivalent to 1.1 million tonnes – has been shut down due to the rising electricity costs.  European production, which is already well below the global average in terms of carbon emissions, was immediately  replaced by carbon-intensive capacity ramp-ups in other regions of the world, resulting in a net increase of 10.3 million  tonnes CO2 increasing during the past year. Instead of protecting European aluminium producers, the CBAM risks  worsening the situation and delivering a hammer blow to this strategic European industry.

Independent studiesshow how a CBAM on indirect emissions would actively discriminate against low-carbon European  production because of the way in which European electricity prices are set (marginal pricing). Therefore, any extension  of CBAM to indirect emissions should only be considered after 2030, by which time the European electricity system should be almost completely decarbonised. This will ensure that the mismatch between indirect carbon costs and  indirect carbon emissions has been reduced to minimum levels. 

For these reasons, European Aluminium supports the European Commission initial proposal and the Council’s General  Approach which stress that indirect emissions in CBAM should not be considered until an adequate methodology mirroring the unique indirect carbon costs producers face in Europe has been developed. Compared to sectors that  are much less trade and electro-intensive than aluminium, including indirect emissions too early will hurt the aluminium transformation industry particularly hard, leading to more carbon leakage and depriving the EU’s future of  a raw material that is key for the green deal and transition to a circular economy.